fabger.blogg.se

One or more packets have been submitted to the radio to be transmitted, but have not been reported as completed for 60 seconds.Ī packet that has completed transmission is reported with an invalid internal memory address. This failure automatically results in a radio coredump written to the flash filesystem.

The radio or radio driver was unable to completely remove a client that is no longer serviced by the radio.Ī completed packet transmission resulted in an unexpected status code from the hardware. The radio has failed to respond to a request to reset the interface. The radio has failed to respond to the "dot11 flash" command. Table 2 Failure (Unexpected) Radio Reset Codes Offchannel in prog is completed while radio waits to be stopped. Reset while setting promiscuous mode serving channel. Indicates that while the radio state should be updated on controller, no reset should be reported. Radio exits inline Cisco Discovery Protocol (CDP) low power mode holddown. Reset while configuring station_role/beamforming/Space-Time Block Coding (STBC) CLI commands Radio interface reset from command routines. Reset due to test Dynamic Frequency Selection (DFS) command. Symbol phone extension support has been enabled or disabled.ĭynamic Frequency Selection debug mode.

Reset on completion of deferred multicast packets. Radio reset due to enable/disable listening to broadcast on 802.11b (for mesh APs). Radio reset prior to reflashing the radio.ĬCK transmit on dual antennas enable or disable.

Radio reset due to Cisco IOS IP address change. Radio reset prior to Cisco IOS software reload. Start radio in special mode for directional antenna alignment.ĭynamic Frequency Selection reset for non-root radio.ĭynamic Frequency Selection reset due to no channels available.ĭynamic Frequency Selection channel change.ĭynamic Frequency Selection reset waiting for available channel. Radio debug tracing is turned on or off, due to start or stop all Dot11 driver tracing. The radio goes into or out of promiscuous monitor mode, due to turn on/off RF monitor promiscuous mode. The radio goes into or out of monitor mode, due to the CLI enabled the Radio Frequency (RF) monitor/store mode.